AbuseMark AfroMini 32 with Metal Case (Original)

In stock

No reward points for this product.


29,90 €

43,20 €

-13,30 €

More info

This is a mini version of Acro Naze32, with machined aluminum case included. This is a design cooperation with MultiWiiCopter Australia, based on the Paris Air Hero enclosure design. For more information and setup for this board, see MultiWiiCopter Paris Air Hero32 pages.
  • PCB 37mm x 21mm, Case 46mm x 27mm x 20mm
  • 27 gram with case and breakout wire, 5 gram PCB only
  • STM32F103CBT6 32-bit Cortex M3 processor
  • MPU6500 Accelerometer/Gyro
  • Flex port for UART/I2C - support bluetooth or serial telemetry
  • Supports 6channel PWM or 8+ channel PPM RC Input
  • Directly supports S-BUS without need for inverter cable (connect S-BUS signal pin to RC channel 4)
  • Supports Spektrum satellite on Flex port
  • 6 motor outputs for Tri/Quad/Hex or Quad + Gimbal
  • Can be powered by up to 16V directly (however note high voltage is passed through to receiver, so receiver must also be capable of 16V) input, unless using Spektrum satellite then it's OK.
  • Micro USB for setup with Baseflight Configurator.
  • Battery voltage monitoring (needs soldering)
  • Buzzer/high power LED output (needs soldering)
A manual for this might be available at some point, however it runs standard baseflight firmware, so all the same features of AcroNaze32 are supported. To mount the board with USB port facing "forward", do "set align_board_yaw=180" from  CLI.
Included in package
  • 1x Acro Naze 32 Mini PCB with headers soldered
  • 1x Aluminum machined case (top and bottom side)
  • 4x Case screw
  • 1x RC Breakout cable for 6 channels

Reviews

No customer comments for the moment.

Write a review

AbuseMark AfroMini 32 with Metal Case (Original)

AbuseMark AfroMini 32 with Metal Case (Original)

 

Write a review

18 other products in the same category:

Customers who bought this product also bought: